FYI, If you decide to attempt any modifications to your HTX, you are doing so at your own risk. HTX Owners Manual HTX/Albrecht AE Service. Update*** I’m still doing this repair for those who may need it. Here are the specifics. I charge a flat fee of $35 which includes the new mic cord, the. Cat. No. OWNER’S MANUAL HTX TWO-METER MOBILE TRANSCEIVER Please read before using this transceiver. INTRODUCTION Your .
|Genre:||Health and Food|
|Published (Last):||6 December 2018|
|PDF File Size:||19.4 Mb|
|ePub File Size:||20.16 Mb|
|Price:||Free* [*Free Regsitration Required]|
This procedure clears all stored information.
Radio Shack HTX-252 Manuals
Manua the fuse in the holder and snap it closed. DTMF Memory 0 holds 7 digits. There are many different types of antennas suitable for manul use. Page 40 Limited One-Year Warranty This product is warranted by RadioShack against manufacturing defects in material and workmanship under normal use for one 1 year from the date of purchase from RadioShack company-owned stores and authorized Ra- dioShack franchisees and dealers. After the transmission, DTMF squelch is still turned on.
To page an individual, you transmit their entire DTMF page sequence. For the calling-frequency memory, press and hold F for one second.
Using the Calling-Frequency Memory. Either way you would like for the manjal to take place is fine with me. The toughest part of this whole ordeal was reusing the stress relief on the microphone itself. T-SQL — appears when both transmit subaudible tone and subaudible tone squelch are turned on.
Radio Shack HTX Owner`s manual |
Hts-252 than —65dB Deviation Type Conventions—make the references to keys and displays easier to find in the text: Spurious and Harmonic Emissions Frequency Error. To turn off auto send, set the option ,anual oFF in Step 4. This may not have been the best way to accomplish this task, but it worked for me. As far as the temperature is concerned, just go with what you feel is right. Then press MR to save all settings.
Connect the supplied polarized Flashes after you hold F for at least 1 second. Apparently this is a very common issue with the cords that they used for this radio. This does not affect the tone-alert beep, alarm scan beep, or the transmit limit beep.
I also recommend using a flux to help in flowing the solder. Press T-SQL a third time to turn off both subaudible tone transmit and squelch. You can set the transceiver to stop transmitting and sound a beep if a single transmission exceeds the selected time none, 1, 2, 3, 5, 7, 10, or 15 minutes.
If auto-reply is turned on, you must hold down PTT while you transmit. To restore the key tone, repeat the procedure.
The HTX includes the selected transmit tone with your transmissions. The default calling frequency is Follow these steps to change the frequency step. Press the push-to-talk button. Follow these steps to change the scan resume delay. Transmitting without a license carries heavy penalties. Follow these steps to change the scanning range. Specifications are subject to change and improvement without notice. FUNC — appears after you press F.
The signal strength meter shows halfscale for low power or full-scale for high power. If squelch is off, the mmanual stops on each location for about 1 sec- ond. Use the supplied screws, metal washers, bracket, rubber washers, and mounting knobs, as shown, to mount the transceiver. Setting the Scan Resume Delay. For exam- ple, if you have set the transceiver to repeater operation on Most repeaters have builtin timers that limit single transmissions to 3 minutes or less.